Still needs a bit of tidying up yet. Inside switches are for the heated seats - red LEDs indicate high setting; yellows indicate medium setting. This just a joke, folks - I wouldn't do this. The may be obtained from a Toyota Corolla cc donor car or Sprinter. This area of modifications can apply to any MGB, whatever the age. Columbus, Ohio, United States. Ed was not confident, so got the local automotive electrician to do it.
Increase the clearance below the bottom of the pump. Most of those available to date will be made in stainless steel. Once again the best reference is to use a rubber bumper car. One of the problems that affects any V8 engined MGB is that the airflow through the engine bay is too restricted. Body Modifications Rubber bumper cars The easiest cars to do are the rubber bumper cars. I like loads of torque for good highway performance, wasn't too worried about extremely light handling for autocross etc, so the heavier and lower reving V6 worked for me.
Adding the fender flares. The conversion is totally non-intrusive to the MGB. We now move onto the more comprehensive kits and there are several alternative suspension kits available. Systems are available in mild steel, stainless steel, standard bore, big bore, twin silencer and single silencer set-ups. The first consideration is to view the expected power of the final engine you are going to use. Master bodyman Don Marcot, pondering his next move. My neighbor when I was a kid had a Chevy in a Sprite.
A further consideration in this area is that when the RV8 style of front pulley parts are used then the crank pulley will probably contact the front anti roll bar, especially if this is a thicker than standard part. Caterham can give you all exact measurements if needed! How about 4cyl engines? Not only does this item support the rack, via two simple brackets welded to the frame , but it also dictates further engine clearance. Flywheel refurbishing, lightening, and pressure plates fitted. Many current engine managed cars now operate with very fine control based on the need for accurate manifold pressure sensing. The will be a tough fit in a Midget chassis, but can be done if you have small feet!